Description

It is a pillar drill from a university in very good condition.

Alzmetall AB 4 SV pillar drill

– Engine power: 2.2/3.3 kW
– Voltage: 380 V
– Speed of the drive motor: 750-1500 rpm
Maximum drilling performance into solid
– For St. 60: 40mm at 0.3mm feed
– For GG 20: 55mm at 0.3mm feed
– Spindle speeds in rpm: 30-765
– Feed rates per spindle revolution: 0.15mm/rev; 0.20mm/rev; 0.30mm/rev; 0.36mm/rev
– Area required: 0.9m x 1.3m
– Height: 1.95m,
– Weight approx. 610kg

work area
– Distance from spindle center to stand or column: 345mm
– Distance from spindle to table top: 164mm – 777mm
– Distance from spindle to base plate: 1214mm

drilling table
– Swivels up to 360°
– Vertical adjustability: 613mm
– Clamping surface: 600x450mm
– Clamping slots: number 2; width 14mm; distance 224mm
base plate
– Height: 105mm
– Clamping surface: 380x450mm
– Clamping slots: number 2; width 16mm; distance 250mm
drill spindle
– Taper: MK 4
– Stroke (drilling depth) itself: 180mm
– Stroke (drilling depth) by hand: 180mm
Special equipment: Foot switch as emergency stop switch